Horizontal Spiral Strip Accumulators

Horizontal Spiral Strip Accumulator
Trouble free accumulators that are responsive to varied production demands.

 

Autonomy and simplicity are critical at the starting gate to the mill. T&H Lemont puts these needs at the forefront of our innovation and construction of accumulator  technology that translates into one important benefit--reliability. The integrated programmable controllers maintain the critical factors for strip processing and feed timing.
Maximum strip storage, combined with separate and unrelated fill/pull speeds allow for the loading and end welding of new feed coils, independent of the mill. Strip feeds on the OD and pulls independently on the ID. The accumulator can fill at high speeds even if the mill is stopped and just as equally feed the mill continuously with no pause, should you experience a temporary delay in reload or end welding.

Made with the most rugged environments in mind--T&H Lemont accumulators offer more than smooth operations for your operator, but a vacation from relentless repair and maintenance that shows up on your bottom line in a cost of ownership almost immediately.

Horizontal Strip Accumulators

Model

OD (in)
Min

OD (in)
Max

Wall Thickness (in) Min

Wall Thickness (in) Max

Line Speed (FPM) Max

Special Comments

280/3.2

0.500"

3.500"

0.028"

0.134"

600

Rollertable type with conventional loop

280/4

0.500"

3.500"

0.040"

0.160"

400

350/4

0.750"

4.250"

0.040"

0.160"

500

Rollertable type with conventional loop

400/5

1.000"

5.000"

0.040"

0.200"

450

600/7

1.500"

7.500"

0.060"

0.280"

400

700/9.5

3.000"

8.625"

0.080"

0.375"

300

850/10

3.500"

10.750"

0.100"

0.400"

300

1100/16

4.500"

12.750"

0.120"

0.625"

250

Rollertable type with conventional loop; inner tower driven.

1600/16

6.000"

16.000"

0.120"

0.625"

200

2000/16

8.625"

24.000"

0.188"

0.625"

150

2000/19

8.625"

24.000"

0.188"

0.750"

150
OPTIONS:
 1) Turning basket for sizes up to and including 600/7
 2) Hydraulic power pump for sizes up to and including 600/7
 3) Pit-less pinchroll for sizes up to and including 600/7
 4) Automatic tail-out sequence using encoder for existing uncoiler (all sizes - higher accuracy)
 5) Automatic tail-out sequence using photo-eye for existing uncoiler (all sizes - higher accuracy)
 6) Coil end detector (all sizes) mounted to existing flattener (requires auto tail-out sequence also)
 7) Localized grease header blocks (for parts inside outer diameter) for sizes up to and including 600/7
 8) Screw adjustments for the twist/detwist stands for sizes up to and including 600/7

Note: Some options may not be available for all sizes and are Customer (i. e. plant, location dependant)

Back To Mill Components Page