T&H Lemont stocks No. 1, 2, 3, and 3-S die sets. These are supplied for flying cut offs, or for recutting operations on a punch press. Long life and durability are inherent in T&H Lemont construction. Bronze wear pads are employed on the rail bearing surfaces and hardened wear plates are provided under the die holding blocks.

All component parts are standardized, and can be replaced immediately from stock. Where extensive repairs are required, it may be more expedient to ship your die to T&H Lemont for a complete rebuilding. A rebuilt die leaves our plant with the same precision and same guarantee as a new die set. Die slides, rails, and other parts for the cut off press are some of the associated equipment also built by T&H Lemont.

T&H Lemont also designs and manufactures special die sets for your specific press and tube size ranges.

Back To Mill Components Page